°Placeyoke end of crank rod around uni- versaljoint, lining up openings.Insert clevis pin through assemblyand secure with cotter pin, Spread ends of cotter pin with a pair of pliers to lock in place, See next figure.
°Tighten nut on eye bolt, keepingeye in line with the rod while tighteningthe inside securely.
•Tighten all handle bolts with a 112inch wrench.
Crank Rod
Clevis pin Asse
joint
pin
TO ASSEMBLE SNOW CHUTE
o Turn crank assembly countercloclcwise until it stops.
o Locate three carriage bolts, flat'washers and nuts (found in parts bag). DO NOT re- move carriage bolt over worm gear.
o Position snow chute on snow chute flange and align the three holes in the snow chute with holes in the snow chute flange as shown in figure below.
o Install
=Tighten carriage bolts securely° Be careful not to overtighten. See figure below.
=Turn crank assembly clockwise and make sure all carriage bolts are tight.
Universal joint |
| |
Bracket |
| |
TO INSTALL SHIFTER LEVER KNOB | Nut, | |
Thread the | Hex Nylon | |
Chute | ||
parts bag onto shifter lever. Thread the | ||
| ||
shifter lever knob onto the threaded end |
| |
of the shifter lever until it is snug against | _now Chute Flange | |
| ||
the hexjam nut and the lip is pointed away |
| |
from the engine. Tighten hexjam nut |
| |
against the bottom of the shifter lever | Carriage Bolts | |
knob. See figure below. | ||
...._ | ||
TO CHECK/ADJUST | CLUTCH | |
CONTROL CABLES |
|
The control cables attached to the auger clutch lever and traction clutch lever as
shown in figure below may need to be ad- justed before you use your snow thrower.
For instructions on checking or adjusting the control cables, (See To Adjust Clutch Control
Cables paragraph on page17).
Traction (_lutch Lever Auger Clutch Lever
OFF __ |
....._,Contro_cll_abIes
7
