Add Engine Oil
1.Place pressurewasher on a fiat, ]eve]surface.
2.Cleanareaaround oil fill and remove oil fill cap/dipstick. NOTE:See Off Recommendations in Maintenancesection. Verify provided oil bottle is the correct viscosity for current ambienttemperature.
3.Using oil funnel (optional), slowly pour contents of both provided oil bottles into oil fill openingto the point of overflowing.
1.Useclean, fresh, regular UNLEADEDfuel with a minimum of 86 octanewith equipment. DO NOTmix oil with fuel.
2.Place pressure washer on a level surface. Cleanarea around fuel fill cap, remove cap.
3.Slowly add regular unleadedfuel to fuel tank. Becareful not to overfill. Allow about 1" of tank space for fuel expansion, as shown here.
MaximumFuelLevel
NOTICE
Improper treatment of pressurewasher can damage it and shorten its life.
DONOTattemptto crankor startthe enginebeforeit hasbeen properlyservicedwith the recommendedoil. Thismayresultin anenginefailure.
4.Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
| WARHIHG |
_Fue] | and its vapors are extremeJy flammable and |
| explosive. |
| death. |
| Fire or explosion can causesevere burns or |
WHENADDINGFUEL
*TurnpressurewasherOFFandlet it coolat least2 rninutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure in tank.
. Fillfueltank outdoors.
*DONOToverfilltank.Allowspacefor fuelexpansion.
*If fuel spills,waituntil it evaporatesbeforestartingengine. Keepfuelawayfromsparks,openflames,pilot lights,heat,and otherignitionsources.
DONOTlight a cigaretteor smoke.
4.Install fuel cap and wait for any spilled fuel to evaporate.
CAUTION!
methanol) can attract moisture, which leads to separation and formation of acids during storage. Acidic gas can damagethe fuel system of an enginewhile in storage.
To avoid engine problems, the fuel system should be treated with a fuel preserver or emptied before storage of 30 days or longer. If adding a fuel preserver, fill the fuel tank with fresh fuel. if only partially filled, air in the tank will promote fuel deterioration during storage. If fuel preserver is not used, drain the fuel tank, start the engine and let it run until the fuel lines and carburetor are empty. Usefresh fuel next season. See Storage for additional information.
NEVERuse engine or carburetor cleaner products in the fuel tank as permanent damage may occur.
