Connect Hose and Water Supply to Pump
NOTE:Removeand discardthe shipping caps from the pump's high pressureoutlet andwater inletbeforeattaching hoses.
NOTICE
DO NOTrun the pump without the water supply connected and turned on.
Damageto equipmentresultingfrom failureto followthis instructionwill void warranty.
Uncoil high pressure hose and attach quick connect end of hose to base of spray gun. Pull down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to be sure of tight connection.
4.Run water through garden hose for 30 seconds to clean out any debris. Turn off water.
IMPORTANT:DO NOTsiphon standing water for the water supply. Use ONLYcold water (less than I O0°F).
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at pump inlet can cause pump or inlet connector damage.
ThereMUSTbeat leastten feetof unrestrictedgardenhose
betweenthepressurewasherinletandanydevice,suchas a vacuumbreakeror checkvalve.
Damageto equipmentresultingfrom failureto followthis instructionwill void warranty.
5.Connectgarden hose (not to exceed50 feet in length) to water inlet.Tighten by hand.
| WARHIHG |
| The high pressure stream of water that this |
_ | quipment produces can cut through skin and its |
| underlying tissues, leadingto serious injury and |
| )ossible amputation. |
*NEVERconnecthighpressurehoseto spraytip extension.
*Keephighpressurehoseconnectedto pumpandspraygun whilesystemis pressurized.
*Alwaysbecertainspraygun,spraytips andaccessoriesare correctlyattached.
2.Similarly, attach other end of high pressure hose to high pressure outlet (A) on pump. Pull down on collar of quick connect, slide onto pump and let go of collar. Pull on hose to be sure of tight connection.
,Before connecting garden hose to water inlet, inspect inlet screen (B). Cleanscreen if it contains debris or have it replacedif damaged. DO NOTrun pressurewasher if inlet screenis damagedor missing.
WARHIHG
Risk of eye injury.
_Spray can splash back or propel objects. Alwayswearsafetygoggleswhen usingthis equipmentor in vicinityof whereequipmentis in use.
Beforestartingthe pressurewasher,besureyouarewearing adequatesafetygoggles. NEVERsubstitutesafetyglassesfor safetygoggles.
6.Turn ONthe water, press red button (C) on the gun and squeezethe trigger to purge the pump system of air and impurities.
C>
Checklist Before Starting Engine
Reviewthe assembled unit to ensure you have performed all of the following:
1.Besure to read Safety Rules and How To Use Pressure Washerbefore using pressurewasher.
2.Makesure handle is in place and secure.
3.Makesure shipping cap was removed and oil dipstick was installed in pump.
4.Checkthat oil has beenadded to proper level in engine crankcase.
5.Add proper fuel to fuel tank.
6.Checkfor properly attached hose connections.
7.Checkto makesure there are no kinks, cuts, or damage to high pressure hose.
8.Provide a proper water supply at an adequateflow.
