ENGINE MAINTENANCE

VVARN[NG

WHEN ADJUSTING OR MAKmNGREPAIRS TO YOUR PRESSURE WASHER

Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.

WHEN TESTBNGFOR ENGINE SPARK Use approved spark plug tester.

DO NOT check for spark with spark plug removed,

Checking 0+[ Level

Oi[ level should be checked prior to each use or at least every 5 hours of operation. Keep o+l level maintained.

Changing OH

Change engine oil after the first 5 hours and every 50 hours thereafter. If you are using your pressure washer under extremely dirty or dusty conditions, or in extremely hot weather, change oil more often.

[ ,A cAu++o.

Used motor oil has been shown to cause skin cancer in certain laboratory animals,

Thoroughly wash exposed areas with soap and water,

KEEP OUT OF REACH OF CHILDREN.

DON'T POLLUTE. CONSERVE

RESOURCES. RETURN USED OIL TO

COLLECTION CENTERS.

5.Wipe dipstick clean, insert it into oil fill hole and tighten securely, remove dipstick. Add recommended oil up to "Full" mark on dipstick.

Pour slowly. Wipe dipstick clean each time oil level is checked. DO NOT overfill.

6.[nstail oil fill plug and dipstick, tighten securely.

7.Wipe up any remaining oil.

8.Reconnect spark plug wire to spark plug.

Service Air Cleaner

Your engine will not run properly and may be damaged if you run it with a dirty air cleaner.

Service the air cleaner once every 25 hours of operation or once each year, whichever comes first. Service more often if operating under dirty or dusty

conditions. Replacements are ava+iabie at your local Sears service center.

To service the air cleaner, follow these steps:

1.Loosen screw and tilt cover down.

Tabs and Slots

Cartridge

Base

ScrewCover

Change oHwhile engine is still warm from running, as follows:

1.Drain fuel tank by running pressure washer until fuel tank is empty.

2.Disconnect spark plug wire and keep it away from spark plug.

3.Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.

4.Tip your pressure washer to drain oi[ from oi[ fiJ[ into a suitabJe container making sure you tip your unit away from spark plug. When crankcase is empty, return pressure washer to upright position.

2.Carefully remove cartridge assembly.

3.To clean cartridge, gently tap pleated paper side on a flat surface.

4.Reinstall clean or new cartridge assembly inside cover.

5.Insert cover's tabs into slots in bottom of base.

6.Tilt cover up and tighten screw securely to base.

NOTE: You can purchase new air filter elements by ca[i+ng 1-800-366-PART.

16

Page 16
Image 16
Craftsman 580.7524 owner manual Engine Maintenance Vvarnng, Changing OH, Service Air Cleaner