Craftsman 580.7524 Long Term Storage, Protect Fuel System, Change Oil, Oil Cylinder Bore

LONG TERM STORAGE

if you do not plan to use the pressure washer for more than 30 days, you must prepare the engine and pump for long term storage.

it is important to prevent gum deposits from forming in essential fuel system parts such as the carburetor, fuel filter, fuel hose or tank during storage. Also, experience indicates that alcohol-blended fuels (called gasohol, ethanol or methanol) can attract moisture, which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Protect Fuel System

Fuel Additive:

if adding a fuel additive, fill the fuel tank with fresh fuel. If only partially filled, air in the tank will promote fuel deterioration during storage. Engine and fue[ can be stored up to 24 months with additive.

•Add fue[ additive following manufacturer's instructions.

•Make sure you have water supply to pump inlet connected and turned ON.

•Run the engine outdoors for 10 minutes to be sure that treated fuel has replaced the untreated fuel in the carburetor.

If fuel additive is not used, remove all fuel from tank and run engine until it stops from lack of fuel.

Change Oil

While engine is still warm, drain oil from crankcase. Refill with recommended grade. See "Changing Oil" on page 16.

Oil Cylinder Bore

•Remove spark plug. Squirt about 1 tablespoon of dean engine oil into the cylinder. Cover spark plug hole with rag. Pull recoil handle slowly to distribute oil. Avoid spray from spark plug hole.

•Instal[ spark plug. DO NOT connect spark plug wire.

Protect Pump

To protect the pump use Sears pump saver to prevent freeze damage and lubricate pistons and seals.

NOTE: Sears pump saver, item number 71-74403, is available as an optional accessory. [t is not included with the pressure washer.

CAUTION

*Failure to do so will permanently damage your pump and render your unit inoperable,

,Freeze damage is not covered under warranty.

To use the pump saver:

,_ CAUTION

Always wear eye protection when using PumpSaver.

1.Attach hose on pump saver can to pump inlet.

2.Push in can top to dispense pump saver.

3.When pump saver fluid begins to exit pump outlet, the pump is protected.

4.Remove pump saver from pump inlet.

OTHER

•DO NOT store fuel from one season to another.

•If possible, store your unit indoors and cover it to give protection from dust and dirt. BE SURE TO EMPTY THE FUEL TANK.

IMPORTANT: NEVER cover your pressure washer while engine and exhaust area are warm.

19