HOW TO USE YOUR PRESSURE WASHER
if you have any problems operating your pressure
washer, please ca+lthe pressure washer helpline at
Pressure Washer Location
Pressure Washer Clearance
DANGER
Operate pressure washer ONLY outdoors,
Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings,
DO NOT operate pressure washer inside any building or enclosure,
The pressure washer must be at least 5 ft. (152 cm) from structures having combustible walls and/or other combustible materials. Leave at least 3 ft. (92 cm) all
around pressure washer including overhead, for adequate cooling, maintenance and servicing.
Place pressure washer in a wel+ ventilated area, which will allow for remova+ of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is kept away from any windows, doors, ventilation intakes or other openings that can allow exhaust gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning pressure washer.
Exhaust Port
To Start Your Pressure Washer
To start your
1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.5 gal+ons per minute and no less than 20 PSI at pressure washer end of garden hose.
2.Check that high pressure hose is tightly connected to spray gun and pump. See "Assembling Your Pressure Washer" for illustrations.
3.Make sure unit is in a level position.
4.Connect garden hose to water inlet on pressure washer pump. Turn ON water.
CAUTtON
+Damage to equipment will result from failure to follow this instruction.
5.Squeeze trigger on gun to purge pump system of air and impurities.
6.Attach nozzle extension to spray gun. Tighten by hand.
\\
7.Position nozzle in low pressure mode (slide nozzle forward) and squeeze trigger on spray gun to relieve pressure caused by turning ON water. Water will flow out of gun in a thin stream. Continue to hold trigger until there is a steady stream of water and no air remains in system. Release trigger.
Engage trigger lock to spray gun trigger.
_ | Trigger Lock |
g.Move throttle lever to "Fast" position, shown here as a rabbit.
,\
\
Throttle Lever in "Fast" Position
