Yourpressurewasherrequiressomeassemblyandis readyforuseonlyafterit hasbeenproperlyserviced withtherecommendedoil andfuel.

if you haveany problemswith theassemblyof

your pressurewasher,pleasecall the pressure washerhelplineat 1-800-222-3136.

iMPORTANT:Anyattemptto runtheenginebeforeit hasbeenservicedwiththerecommendedoilwillresult

in anenginefailure.

REMOVE PRESSURE WASHER FROM CARTON

Slice two corners opposite guide handle end of

carton from top to bottom so the panel can be folded down flat.

Remove fillers, accesodes and parts bag shipped with your pressure washer.

Roll the pressure washer out the open end of the carton.

Check carton for additional loose parts.

Attach Handme

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle

align with holes on handle supports.

 

 

f

 

/

 

 

i

_

// Handle

i"

Align Holes,_i

 

'__

 

 

_]

Handle

i

 

//

Supports

l

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of unit and attach a plastic knob from inside of unit. Tighten by hand.

CARTON CONTENTS

Check all contents. If any parts are missing or damaged, call the pressure washer helpline at 1-800-222-3136.

The main unit

Handle

Spray gun

High pressure hose

Nozzle extension with Hi/Lo adjustable nozzle Engine oil

Parts bag (which includes items listed below) Owner's manual

Registration card

Handle attachment hardware

Become familiar with each piece before assembling the pressure washer. Check all contents against the illustration on page 5. If any parts are missing or

. Insert one "L" hooks through hole just under billboard on left side of handle (viewing from rear of unit). Hold hook in place and attach plastic knob from inside of unit. Tighten by hand.

damaged, call the pressure washer helpline at 1-800-222-3136.

ASSEMBLING YOUR PRESSURE WASHER

I

Hose Hook

Your Craftsman high pressure washer was mostly assembled at the factory. However, you will need to perform these tasks before you can operate your pressure washer:

1.Attach handle.

2.Add oil to engine crankcase.

3.Add fuel to fuel tank.

4.Connect pressure hose to spray gun and pump.

5.Connect water supply to pump.

. Insert other "L" hook through hole just above billboard on right side of handle (viewing from rear of unit). Hold hook in place and attach plastic knob from inside of unit. Tighten by hand.

Page 6
Image 6
Craftsman 580.7524 owner manual Remove Pressure Washer from Carton, Carton Contents, Assembling Your Pressure Washer