Craftsman 79585 manual Customer Responsibilities, Generalrecommendations, Chipper-Shredder

CUSTOMER RESPONSIBILITIES

MAINTENANCE SCHEDULE
FILL IN DATES
AS YOU COMPLETE					/	SERVICE
REGULAR		SERVICE
						DATES
p-						4
to	Oil	Pivot		Points
a
O	Clean		Shredder		*/	4
n-
D,.
	Check		Engine Oil		-_/
	Change			Engine Oil	_J	*J
	Service			Air Cleaner

,,=, Clean Engine Cylinder

Spark Plug

Muffler

_/ CHECK

GENERALRECOMMENDATIONS

AND DISCONNECT THE SPARK PLUG

_ WARNING: ALWAYS STOP THE ENGINE

WIRE BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS,

•Periodically check all fasteners and be sure they are tight.

•Follow the Maintenance Schedule above.

CHIPPER-SHREDDER

LUBRICATION

Lubricate the pivot points on the release bar, hopper assembly, chute deflector and chipper chute once a season using a light oil.

CLEANING

•The chipper-shredder may be cleaned by running water from a hose through the hopper assembly and chipper chute with the engine running. Allow the chipper-shredder to dry thoroughly.

•Wash the bag periodically with water. Allow to dry thoroughly in the shade. Do not use heat.

ENGINE

ENGINE OIL

Only use high quality detergent oil rated with API service classification SF, SG or SH. Select the oil's viscosity grade according to your expected operating

temperature.

_'	4'
_	-_
_f
Colder <	32°F	_ Warmer
	5W30	SAE 30

NOTE: Although multi-viscosity oils (SE30, 10W30, etc.) improve starting in cold weather, these multi- vis- cosity oils will result in increased oil consumption when used above 32°F. Check your oil level more fre- quently to avoid possible engine damage from run- ning low on oil.

Your four-cycle engine will normally consume some oil--therefore, check engine oil level regularly approx- imately every five hours of operation and before each usage. Stop engine and wait several minutes before checking oil level. With engine level, the oil must be to FULL mark on dipstick (refer to figure 12). Change engine oil after the first five hours of operation, and every twenty-five hours thereafter.

To Drain Oil:

•Drain oil while engine is warm.

a.Remove oil drain plug. Refer to figure 12. Catch oil in a suitable container.

b.When engine is drained of all oil, replace drain plug securely.

•Refill with fresh oil. Refer to GAS AND OIL FILL- UP section.

•Replace dipstick.

12