![](/images/new-backgrounds/1098202/9820247x1.webp)
7.Push clutch cable housing guide into
bracket, slide collar onto guide and secure with large retainer spring.
8.Place flat washer and clutch spring on
idler pulley bolt and secure with small retainer spring.
9.Install belt onto engine pulley.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this
manual). If tires are over or underinflated, you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
•Raise mower to its highest position.
•At the midpoint of both sides of mower, measure height from bottom edge of
mower to ground. Distance "A" on both sides of mower should be the same or
within 1/4" of each other.
•Before making any necessary adjust- ments, check that both front links are
equal in length.
•If links are not equal in length, adjust one link to same length as other link.
•To lower front of mower loosen nut "E"
on both front links an equal number of turns.
•When distance "D" is 1/8" to 1/2"
lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten
nut "E" on both front links an equal num- ber of turns. The two front links must
remain equal in length.
•When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut "F" against trunnion on both front links.
•Recheck
• | If adjustment | is necessary, | make adjust- | ||||
| ment on one side of mower only. |
| |||||
• | To raise | one | side of mower, | tighten | lift | ||
| link adjustment nut on that side. |
| |||||
• | To lower | one | side of mower, | loosen | lift | ||
| link adjustment nut on that side. | Both Fron_ Links Should be E_qualin Length | |||||
|
|
|
|
|
|
| |
NOTE: Each full turn of adjustment nut | |||||||
will change | mower height | about | 1/8". |
| |||
• | Recheck | measurements | after | adjusting. | |||
Bottom edge |
|
| Bottom edge of | ||||
of mower to |
| _ | mower to ground |
ground _l_l/
t _E _
Arm
kidf uLstrkent Nut_
front links equally so mower will stay level
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.
Check adjustment on right side of trac- tor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
Front Links
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive belt may be re- placed without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
1.Remove mower from tractor (See "TO REMOVE MOWER" in this section of
manual).
2.Work belt off both mandrel pulleys and idler pulleys.
3.Pull belt away from mower.
24