Craftsman 917.27537 owner manual Muffler, Spark Plugs, IN-LINE Fuel Filter

6.Remove the drain tube and replace the cap onto the end of the drain valve.

7.Refill engine with oil through oil fill dip- stick tube. Pour slowly. Do not overfill.

For approximate capacity see "PROD-

UCT SPECIFICATIONS" section of this manual.

8.Use gauge on oil fill cap/dipstick for checking level. For accurate reading, tighten dipstick cap securely onto the tube before removing dipstick. Keep oil at "FULl" line on dipstick. Tighten cap onto the tube securely when finished.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

AIR FILTER

Your engine will not run properly using a dirty air filter. Replace pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every

6.Align tabs on cover with slots in blower housing and replace cover.

7.Hook handle on cover and push down on handle to close.

IMPORTANT: Petroleum solvents, such as kerosene, are not to be used to clean the cartridge. They may cause deterio- ration of the cartridge. Do not oil car- tridge. Do not use pressurized air to clean cartridge.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from

overheating. Clean with a wire brush or compressed air to remove dirt and stub- born dried gum fibers.

ENGINE COOLING SYSTEM

Debris may clog the engine's air cool-

ing system. Remove blower housing and clean area shown to prevent overheating and engine damage.

100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under

dusty conditions.

1.Pull up on air filter cover handle and rotate towards engine.

2.Remove cover.

3.Carefully remove air filter cartridge and pre-cleaner from base.

4.Clean base carefully to prevent debris from falling into carburetor.

NOTE: If very dirty or damaged, replace cartridge.

5.Place new pre-cleaner and cartridge firmly in base.

Air Screen

MUFFLER

Clean out chaff and debris

_ Handle

Inspect and replace corroded muffler and spark arrester (if equipped) as it could cre- ate a fire hazard and/or damage.

SPARK PLUG(S)

Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs

first. Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS"

section of this manual.

IN-LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel filter becomes

clogged, obstructing fuel flow to carbu- retor, replacement is required.

1.With engine cool, remove filter and plug fuel line sections.

2.Place new fuel filter in position in fuel line

with arrow pointing towards carburetor.

Tabs3. Be sure there are no fuel line leaks and

20clamps are properly positioned.