| 4. | Open the petcock (see F) to allow moisture to drain from | ||
1. | Checktheoillevelinthepump(see"CheckingtheOil"inthe |
| the tank. |
|
|
|
| ||
| maintenancesection). |
| __Escaping | air and moisture can |
2. | TurnthepressureswitchtotheOFFposition(seeC). |
| ||
| propel debris that may cause eye injury. Wear safety | |||
3. | Openthepetcock(seeF).Turninthecounterclockwise |
| ||
| goggles when | opening petcock. | ||
| direction. |
| ||
|
|
|
| |
__Escaping
air and moisture can
propel debris that may cause eye injury, Wear safety goggles when opening petcock,
4.Plug in the power cord.
5.Turn the pressure switch to the ON position (see D). The compressor will start. Allow the compressor to run for 30 minutes, to break in the internal parts.
NOTE: After about 30 minutes, if the unit does not operate properly, SHUT DOWN IMMEDIATELY, and contact a Sears or other qualified service center.
6.After about 30 minutes, turn the pressure switch to the OFF position.
7.Close the petcock (see E). Turn in the clockwise direction.
8. | Turn | the pressure | switch to the ON position. | The | Fig. 6 | ||
| compressor wilt start and fill the tank to the | ||||||
|
| ||||||
| pressure and stop. |
|
|
|
| ||
NOTE: | As compressed air is used, the | pressure switch will |
| ||||
|
| restart the motor automatically to supply more |
| ||||
|
| compressed air to the tank. |
|
|
| ||
DAILY |
|
|
|
| OFF (C) | ||
1. | Check the oil level | in the pump (see | "Checking the Oil" in the | (D) AUTO | |||
| maintenance section). |
|
|
|
| ||
2. | Turn | the pressure | switch to the OFF | position (see C). |
| ||
3. | Close the tank petcock (see | E). Turn | in the clockwise |
| |||
| direction. |
|
|
|
|
| |
4. | Plug | in the power | cord. |
|
|
|
|
| __ | High | temperatures | are generated |
| ||
|
| by the electric motor and the pump. To prevent |
| ||||
|
| burns or other injuries, DO NOT touch the |
| ||||
|
| compressor while it is running. Allow it to cool |
| ||||
before handling or servicing. Keep children away from the compressor at all times.
5.Turn the pressure switch to the ON position (see D).
6.Adjust the regulator to the working pressure of the tool.
__Whenadjusting from a higher to a
lower pressure, turn the knob counterclockwise past the desired setting, then turn clockwise to reach the desired pressure. Do not exceed operating pressure of the tool or accessory being used.
SHUTDOWN
1.Turn the pressure switch to the OFF position (see C).
2.Unplug the power cord.
3.Reduce pressure in the tank through the outlet hose. You can also pull the relief valve ring (see G) and keep it open to relieve pressure in the tank.
FOPEN
\ | CLOSE E |
| ./ |
8 |
