INSTALLINGBITS
See Figure 6.
•Lock the SWitCh trigger by placing the direction of rotation selector in center position, See Figure 2.
•Open or clor,e chuck jaws to a point where the opening is sligh_y larger than the bit size you intend to use, Also, raise the front of your drill slightly to keep the bit from fol_ing out of the chuck jaws.
•Insert drill bit into chuck the full length of the jaws as shown in Figure 6.
CHUCKJAWSCHUCKBODY
DRILL BIT
CHUCK COLLAR
RIGHT | Fig. 6 |
•11ghtonthechuckjawsonddllbit.
•TO tighten the chuck jaws on ddll bit; grasp and
hold the collar of the chuck with one hand, while rotating the chuck body with your other hand.
Note: Rotate the chuck body io the direction of the arrow marked LOCK to tighten chuck jaws.
•Do not use a wrench to tighten or loosen the chuck jaws.
_k WARNING: Do not insert drill bit into check jaws and tighten as shown in figure 7. This could cause
dnll bit to he thrown from ditlLresulting in possible serious personal injury or damage to the chuck.
Fig. 7
REMOVING BITS
See Figure 6.
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 2.
•Loosen the chuck jaws from dnll bit.
•To loosen: grasp and ho_dthe collar of the chuck with one hand, while rotating chuck body with y_Jr other hand, Note: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.
•DO not use a wrench to tighten or loosen the chuck jaws.
•Remove ddl] bit from chuck jaws.
ADJUSTABLE TORQUE CLUTCH
Your dhll is equipped with an adjustable torque clutch for driving different types of screws into different matehels. The proper setting depends on the type of matorlal and the size of screw you are using.
TO ADJUST TORQUE
•Identify the six torque indicator settings located on the front of your ddll. See Figure 8.
•Rotate eqjusting dng to the desired seffing.
1For driving small screws.
2For driving screws into soft material.
3For driving screws into soft and herd matohels.
4For ddving screws In hard wood.
5For driving large screws.
•,1!1 Forheavyddlling.
TODECREASE,U)JIJ$11NG
TO_OUERING
TORQUE
TO INCREASE
10
