Craftsman 973.111330 owner manual Do not Operate Charger with a

RULESFORSAFEOPERATION(Continued)
• AnextortioncordshouMnotbeused unless	•
absolutely necessary. Use of improper
extenalon cord could resuh in a risk of fire and
electric shock, if extension cord must be used,
mske s.ure:	•

a.Tnst plrm on plug of extension cord are the same number, size and shape Its those of plug on charger.

b. That extension	cord is properly wired and in			•
good electrical ccad_on; and
c. That wire size is large enough for AC
ampere rating of charger as specified
below:				•
Cord Length (Feet)	25'	50'	100'	•
Cord Size (AWG)	16	16	16	•

Note: AWG = American Wire Gage

DO NOT OPERATE CHARGER WITH A

DAMAGEO CORD OR PLUG, If damaged, have replaced immediately by a qualified sePAceman.

Do not operate charger ff it has i'l)c_Jveda sharp blow. been dropped, or otherwise

damaged in any way; take It to a qualified servtcettlan.

Do not disassemble charger; take it to a qualified serviceman when service or rapalr is required. Incorrect reassembly may result In a risk of electric shcck or fire.

To reduce risk of electric sho_k, unplug charg( from outlet before attempting any maiotensnc_ or cleaning. Turning off controls will not reduc_ this risk.

Do not use charger outdcors.

Disconnect charger from power supply when not in use.

SAVE THESE INSTRUCTIONS. Refer to then frequently and use them to instruct others whq may use this tool. If you loan someone this tc, loan them these instructions also.

Look for this symbol to point out important safety precautions. It means attention!!! Your safety is involved.

SAVE THESE INSTRUCTIONS

IMPORTANT INFORMATION FOR RECHARGING HOT BA1TERIES

When using your drill-driver continuously, the batteries in your battery pack will become hot. You should let a h_ battery pack coof down for approximately 30 minutes before attempting to recharge.

Note: This situation only occurs when continuous use of your drill causes the batteries to beeome hot. It does not occur under normal circumstances. Refer to "CHARGING BATTERY PACK" for normal recharging of betteri'-_. If the chsrger does no*_chsrge your b_ttenj pack under normal circumstances, rstum both the batten pack and charger to your nearest Sears repair center for electrical check.

,_ WARNING:

The opera, on of any power toot can resu_ in foreign objects being thrown k_to your eyes, which can result in severe eye damage. Before beginning power tool operation, always we safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shidids, avalledio at Sears Retail Stores.