NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS
OPERATION
Get to know your snow blower and its controls. Be sure you (or any other operator) have read and understood the Operation Precautions listed on page 2 of this manual.
|
|
|
| Traction | Drive |
|
|
| Auger | Drive | Clutch | Lever |
|
|
| Clutch | Lever | \ | Traction Drive Cable | |
|
|
|
|
| ||
| Oil Fill Cap/Dipstick |
|
|
|
|
|
| Primer Button |
|
|
| Remote Chute | Control |
|
|
|
|
|
| |
Carburetor |
| Auger |
|
|
| |
|
|
|
|
|
| |
Cover |
|
|
|
|
|
|
|
|
| Select |
|
| |
|
|
| Lever |
|
| |
| Starter Handle | Headlight |
| Snow | Chute | |
|
| Deflector Auger Housing | ||||
|
| Assembly |
| |||
|
|
|
|
| ||
Choke | \ |
|
|
|
|
|
|
|
| Toolbox |
|
| |
Ignition Key
Throttle Control
Lever
Height
Adjust Skid
Figure 13
ENGINE AND SNOW BLOWER OPERATING CONTROLS
The engine operating controls and their functions are as follows:
Throttle Control Lever - This snow blower is equipped with an engine mounted throttle control lever used to start a cold engine.
Choke Lever- Set choke lever to ON CHOKE position to start a cold engine.
NOTE: Do not move speed select lever while Traction Drive Clutch is engaged. This may result in severe damage to drive system.
Auger Drive Clutch Lever- Used to engage and disengage
the auger and impeller. To engage push down, to disengage release.
Traction Drive Clutch Lever- Used to propel snow blower forward or reverse. Push down to engage, release to
Electric Start Button- Used to start the engine using the 120 volt electric starter.
Prime Button- Used to inject fuel directly into carburetor manifold to insure fast starts in cool weather.
Ignition Key- Must be inserted into ignition key slot to start engine. Pull out to stop. Do not turn ignition key.
Starter Handle- Starts the engine manually.
The snow blower operating controls and their functions are as follows:
Speed Select Lever- | Allows the operator to use one of six |
(6) forward and two (2) reverse speeds. To shift, move speed | |
select lever to desired | position. |
12 | |
disengage.
Snow Chute Deflector- Changes the direction the snow is blown.
Remote Chute Deflector Lever- Push remote lever forward to discharge snow high and far. Pull remote lever back to discharge snow down.
Crank- Used to change direction of the snow discharge.
Turn handle clockwise to turn chute to right. Turn handle counter clockwise to turn chute to left.
Height Adjust Skid- Used to adjust ground clearance of auger housing (see To Adjust Skid Height in the Adjustment/Repair section of this manual).
Toolbox - Spare shear pins and spacers are located in toolbox.
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/
