NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS
ASSEMBLY
Figure 1 shows the snow blower in the shipping position.
Figure 2 shows the snow blower completely assembled.
Reference to right and left hand side of the snow blower is from the operator's position at the handle.
UNPACKING
1.Locate and remove the fuel stabilizer and the parts bag.
NOTE: Place fuel stabilizer in a safe place until needed for storage.
2.Cut and discard the plastic ties securing the chute crank assembly to the top pallet, place chute crank assembly aside. Discard pallet.
3.Locate all parts packed separately and remove from car- ton.
4.Cut all four corners of the carton from top to bottom and lay the panels flat.
5.Remove and discard the packing material from around the snow blower. Cut any straps that are holding snow blower to lower pallet.
6.Roll the snow blower off the carton by pulling on the lower handle.
CAUTION: DO NOT back over cables.
7.Remove the packing material from the handle assembly.
8.Cut ties securing the clutch control cables to the lower handle.
NOTE: If the cables have become disconnected from the clutch levers, reinstall the cables as shown in Figure 3.
o o
Speed
Selector
Lever
Auger
Drive
Cable
Height Adjust
Skid
!l
Figure 1
Traction Drive
Clutch Lever
Traction
Drive
Remote Crank
Assembly
Snow Chute
Deflector
Auger Housing
Figure 2
Traction Drive Lever
Figure3
7 |
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/
