NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS
TROUBLE SHOOTING CHART
PROBLEM | LOOK | FOR | REMEDY |
|
| ||
Difficult | starting | Defective | spark plug. | Replace defective | spark plug. | ||
Engine | runs erratically | Blocked | fuel line. | Clean fuel | line. |
| |
|
| Empty | gas tank. | Check fuel | supply, |
| |
|
| Stale | gasoline. | Add fresh | gasoline. |
| |
|
| Water or dirt in fuel system. | Remove carburetor | bowl to drain fuel tank. Refill | |||
|
|
|
|
| with fresh fuel. CAUTION: Do not remove | ||
carburetor bowl when the engine is hot.
Engine stalls | Unit running | on CHOKE. |
Loss of power | Gas cap vent hole is plugged. | |
Excessive vibration | Loose parts | or damaged impeller. |
Unit fails to propel Drive belt loose or damaged. itself
Incorrect adjustment of traction drive cable.
Worn or damaged friction disc.
Set choke lever to RUN position.
Remove ice and snow from cap. Be sure vent hole is clear.
Stop engine immediately and remove spark plug wire. Tighten all bolts and make all necessary repairs. If vibration continues, have the unit serviced by a competent repairman.
Replace drive belt. Refer to Drive Belt
Replacement in Adjustments/Repairs section of this manual.
Adjust traction drive cable. Refer to Cable
Adjustment in Adjustments/Repairs section of this manual.
Replace friction disc. Refer to Friction Wheel
Replacement in Adjustments/Repairs section of this manual.
Unit fails to discharge Auger drive belt loose or damaged.
snow
Replace or adjust auger drive belt. Refer to Drive Belt Replacement and Drive Belt Adjustment in
AdjustmentslRepairs section of this manual.
Auger control cable not adjusted | Adjust auger | control | cable. Refer to Cable | |
correctly. | Adjustment | in Adjustments/Repairs | section of | |
| this manual. |
|
|
|
Broken shear bolt. | Replace shear bolt. | Refer to Auger | Shear Bolt | |
| Replacement | in Adjustments/Repairs | section of | |
| this manual. |
|
|
|
Discharge chute clogged. | Stop engine | immediately and disconnect spark | ||
| plug wire. Refer to the first Warning in Snow | |||
| blower Operation in Operation section of this | |||
| manual. Clean discharge chute and inside of | |||
| auger housing. |
|
| |
Foreign object lodged in auger.
Stop engine immediately and disconnect spark plug wire. Refer to the third Warning in Snow blower Operation in Operation section of this manual. Remove object from auger.
Identifying Your Snow blower
Your new Snow blower has two (2) identifying numbers: (1) unit model number: (2) unit serial number. The two preceding numbers are required to insure that the proper replacement parts are obtained when required. If you have any questions concerning parts, service, or technical data, contact your nearest Sears Service Department.
For complete warranty information refer to the warranty in the Owner's Information section of this manual.
32 |
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/
