![](/images/new-backgrounds/1060153/6015393x1.webp)
CertainTeed Vinyl Siding Installation Guide
rain tab | Installing Window and Door Trim | |
| Install | |
| around windows. | |
| NOTE: When installing | |
1" | windows that do not have nail flanges, add flashing for | |
greater protection against water infiltration. For an example | ||
| ||
| of completed flashing, see the previous page. | |
| There are two methods of joining | |
| easiest method is to square cut the corners. For a more finished | |
| appearance, you can miter the corners. To prevent gaps, do not | |
| butt ends. Instead, lap them as shown. |
1"
rain tab
| To square cut corners |
| Install |
| as shown. |
| NOTE: For best results, use aviation snips when cutting |
|
|
| Cut the top and bottom |
| the casing to the width of side |
1" | Place the top |
| the wall. |
rain |
| Make two cuts in the bottom of the upper channel and bend it |
tab |
| down to overlap the side |
|
| This forms a water drain and allows the |
|
| siding panel. |
1" |
| Nail the bottom |
|
| |
|
| described. Fold the rain tabs into the receiving pockets for a |
1" or |
| tighter miter joint. |
|
| |
dimension |
|
|
of |
| To miter cut corners |
face) |
| |
| For best results, make sure you cut all | |
|
| |
|
| length, leaving the proper allowance for the width of the face of |
|
| the |
|
| Square cut the bottom |
|
| the window casing to the width of the face of the side |
|
| Notch the ends for clearance. Position and nail the |
1" |
| Measure the side |
| and bottom | |
|
| |
|
| of both side |
|
| position it and nail. |
rain | 1" | Mark the top |
tab | the width of the side |
Cut and bend rain tabs. Position and nail.
NOTE: You can create blind miters on a
46