![](/images/new-backgrounds/1060153/60153109x1.webp)
CertainTeed Vinyl Siding Installation Guide
1/8" per side
make 1" cuts
Corner Blocks
Corner block
Install 1/2"
Cut the top and bottom lineals 1/4" longer than the window.
Using vinyl snips, make two 1" long cuts in the pocket areas on both sides of each lineal. These cuts allow the lineals to connect with the corner block and help provide proper drainage.
NOTE: It may be helpful to hold off securing the lineals until the corner block is in place.
Position the corner block by inserting the top lineal into the corner block’s receiving
Position the vertical (side) lineal into the corner block by inserting the pocket of the corner cover into the pocket of the lineal.
This will ensure proper drainage.
rosette
center (back
Corner block with rosette
Locate the small dimple on the back side of the block’s face or measure
Drill or punch a 3/32" to 1/8" diameter hole through the face of the
NOTE: Check the back side of the block for this location— marked by “+”.
Apply the rosette clip from the backside. If desired, a small amount
side)
rosette clip
of caulk can be applied over the hole prior to applying the rosette.
54