![](/images/new-backgrounds/1060153/60153185x1.webp)
CertainTeed Vinyl Siding Installation Guide
vinyl | undersill trim |
fascia |
|
cap |
|
fascia board
nail in slot opening
1/8"
3/4"
Vinyl Fascia
The wooden fascia board that encloses the front of an eave also needs protection from the weather. To provide this protection, you can install vinyl or aluminum fascia panels.
There are two procedures for installing vinyl fascia
Installations without soffit
Nail undersill trim in place along the top of the fascia board.
Before installing the panel, create tabs along the top edge using a snap lock punch.
Hook the bottom of the fascia panel under the bottom of the fascia board. Push the top edge into the undersill trim,
as shown, or behind drip edge.
Secure the panel to the bottom of the fascia board with white trim nails. Fasten at nail slot openings only (see illustration). Do not face nail fascia panel.
When overlapping fascia panels, first cut a notch in the underlying panel. The notch should be 1/8" deep by
To turn a corner, you must first fabricate a corner piece.
Cut a length of fascia panel so it extends 6" beyond the corner. Mark a vertical line to indicate the position of the corner. Then cut a 90°
Fit the panel on the corner, making sure to overlap the preceding panel.
snap lock
punch
92