Scanning stations in DAB mode

When scanning stations for the first time, opt for the automatic full scan.

Automatic full scan

•LCD displays may vary from region to region.

•Extend or adjust the antenna, or relocate the radio, to find the best reception.

There are three ways to scan for stations:

•Automatic full scan

•Quick scan

•Manual scan

To do an automatic full scan

1.Press and hold the AUTOTUNE button to begin automatic scanning of all ensembles* in Band III (see “Glossary” on page A-1). This may take a few minutes, during which you will see the displays in the sequence below. When a station is detected, it plays immediately.

**

Figure 3-4

2.To preview another station, turn the TUNING knob until the name of another station appears.

3.Press the TUNING knob to select and listen to the new station.

•* A group of stations being broadcasted on the same frequency or channel is called an ensemble.

•** The empty block indicates the minimum required level for reception and the filled blocks indicate current signal strength. For more information on the display shown, see “Viewing additional information (INFO display)” on page 3-6.

Using Your SoundWorks 500DAB 3-2