Cub Cadet 8354 manual Main Slow Blow Fuse, Tire Maintenance

15A	Spare
10A	Horn, Cab Lamp	10A	PTO
25A	Turn Signal Lamp	20A	Rear Lamp
	Timer Relay		Head Lamp
20A	Working Lamp
15A	Wiper	10A	Backup Lamp
10A	Brake Lamp	10A	Start Switch "ON"

Figure 78

•If a fuse continually fails, have the electrical harnesses check by your Cub Cadet dealer or a qualified electrician.

Main Slow Blow Fuse

•Locate the slow blow fuse in the wire harness behind the left side panel. See Figure 79.

Slow Blow Fuse

TIRE MAINTENANCE

Check the tire air pressure before each use. Keep the tires inflated to the recommended pressures. Improper inflation will shorten the service life of a tire. See the tire side wall, or the Tire Inflation chart, for proper inflation pressures.

Classification	Tire Size			Inflation
				Pressure
Front Tires	7-16	4PR		25.7 psi
	8-16	6PR		22.9 psi
Rear Tires	11.2-24		6PR	25.7 psi
	12.4-24		6PR	22.9 psi
	13.6-24		6PR	22.9 psi

•Do not inflate a tire above the maximum pressure shown either on the sidewall of the tire or the Tire Inflation chart.

•Do not reinflate a tire that has been run flat or seriously under inflated. Have a qualified tire mechanic inspect and service the tire.

Figure 79

•Remove the coupling and replace the old slow blow fuse with a new one.

IMPORTANT: The slow blow fuse serves to protect the electrical system. If the fuse blows, have the tractor electrical system checked to find the cause. Never substitute a different fuse.

•WHEN SEATING THE BEADS, NEVER INFLATE A TIRE OVER 35 PSI. If the tire beads have not seated at or before 35 PSI, allow the tire to deflate. Reposition the tire on the rim, lubricate the tire beads and rim flanges, and reinflate until seated - up to a maximum of 35 PSI. Inflating a tire with unseated beads beyond 35 PSI could break the bead or rim with sufficient explosive force to cause a serious injury.

WARNING: Servicing tires can be danger- ous. Whenever possible, trained person- nel should service and mount tires.

48