4.4 Installation
4.4.1 Wall Mounting the UPS | |
1. | Remove the UPS from the carton. |
2. | Get the wall mount kit. |
3. | Use the nuts included in the kit. |
| Attach both wall mount brackets to |
| the threaded posts on the back side |
| of the UPS enclosure as shown on |
| the right. |
4. | Reference the Wall Mount Chart |
| |
| mark the four mounting hole |
| locations. |
5. | |
| to a suitable size (M8 is |
| recommended) for the fasteners |
| being used. |
6. | Install the fasteners and mount the |
| UPS to the wall. |
4.4.2 Pole Mounting the UPS (Optional) | |
Wall Mount
Bracket Post
Poll Mount
Bracket Post
Figure 7: Wall Mount Kit
Poll Mount
Bracket (Left)
1. | Remove the UPS from the carton. |
2. | Get the pole mount kit (ordered |
| separately) |
3. | Using the nuts included in the kit, |
| attach the left and right pole mount |
| brackets to the threaded posts on |
Center Bracket
Poll Mount Bracket (Right)
| the back side of the UPS |
| enclosures as shown. |
4. | Thread the (4) M8 x 25L hex head |
| screws with a lock washer and flat |
| head washer onto the center pole |
| mount bracket. |
5. | Using pole mount straps (not |
| provided), attach the center bracket |
| to the pole. |
6. | Hang the UPS (batteries not |
| installed) onto the center poll mount |
| bracket which is already on the poll. |
7. | Tighten the 4 screws. |
Note: Using stainless or galvanized steel straps with a width of
"Warning: Risk of Electric Shock. Mount the unit at a height greater than 25cm from the ground surface."
Tread screw and two washers onto center bracket
Figure 8: Pole Mount Kit
Figure 9: Pole Mounting Diagram
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. | Page: 9 of 17 |
