1 |
Hardware Preparation and Installation
6.At the other three corners of the base board, install long (0.737 inch) standoffs.
7.Place the PMC carrier board on top of the base board. The connector on the underside of the carrier board should connect smoothly with the corresponding connector J5 (located between P1 and P2) on the MVME2603/2604.
8.Insert the four short Phillips screws through the holes at the corners of the carrier board, into the standoffs on the MVME2603/2604. Tighten the screws.
9.Reinstall the MVME2603/2604 assembly in its proper card slot. Be sure the module is well seated in the backplane connectors. Do not damage or bend connector pins.
10.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source, and turn the equipment power on.
MVME2603/2604 VME Module Installation
With mezzanine board(s) installed and headers properly configured, proceed as follows to install the MVME2603/2604 in the VME chassis:
1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.
2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME modules.
Inserting or removing modules with power applied may result in damage
!to module components.
Caution
Computer Group Literature Center Web Site |
