Motorola MVME2600 manual PMC Module Placement on MVME2603/2604

Hardware Installation

4. Remove the PCI filler from the front panel.

1

11661.00 9611 (3-3)

Figure 1-19. PMC Module Placement on MVME2603/2604

5.Slide the edge connector of the PMC module into the front panel opening from behind and place the PMC module on top of the base board. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors (J11/12/13/14) on the MVME2603/2604.

6.Insert the two short Phillips screws through the holes at the forward corners of the PMC module, into the standoffs on the MVME2603/2604. Tighten the screws.

7.Reinstall the MVME2603/2604 assembly in its proper card slot. Be sure the module is well seated in the backplane connectors. Do not damage or bend connector pins.

8.Replace the chassis or system cover(s), reconnect the system to the AC or DC power source, and turn the equipment power on.

http://www.motorola.com/computer/literature 1-39