Alamo JD-5205, JD-5525, JD-5425, JD-5225, JD-5105, JD-5325 manual Inner Shoe Weldment Replacement

Figure 19

Asy. Man) 05/05

INNER SHOE WELDMENT REPLACEMENT

Inner Shoe Weldment Replacement:

The Inner Shoe Weldment replacement will require other components to be removed in order to replace the weldment. Removal or disconnection of hydraulic line will not be required. DO NOT Start tractor after this repair has began, secure tractor from starting and set parking brake on tractor.

1.Inner Skid Shoe Plate will have to be removed, See inner shoe replacement on previous page (See Figure 17 & 18).

2.Drive Assembly will need to be removed,

See cutter bar assembly replacement on previous pages (See Figure 10).

3.Cutter Bar Assembly will need to be removed, See cutter bar assembly replacement (See Figure 10).

4.The Rotor Actuator is a hydraulic operated break-a-way unit. Before starting repair put a drain pan under rotor actuator. The hoses at the actuator should be loosen slowly, but NOT Removed to relieve pressure in lines and actuator. Make certain that it is the hose at the actuator and not the control or the relief valve block. After the pressure if any has been relieved the hoses can be retightened. This is important DO

NOT try to unbolt Actuator Pin or any other frame component until the hoses have had the pressure relieved. (See Figure 19, 20 & 21)

5.The Skid Shoe weldment can be removed with the Rotor Actuator attached to skid shoe weldment and then removed or it can be left bolted to Back Pivot Plate. The rotor actuator is not part of the skid shoe weldment. To remove the actuator from skid shoe remove the 8 bolts that retain break-a-way rotor ac- tuator pin. The rotor Actuator pin goes all the way through the shoe weldment and can be re- moved by pushing up on pin from bottom (See Figure 19, 20

&21) 6. The Back Plate is retained by 3 bolts which mount it to the Carriage Arm, It is not required to remove the Back Pivot Plate to remove skid show weldment. It must removed, re- move the three retaining bolts to drop the back plate.

Short Tube Spacer

Break-A-Way Rotor Actuator Pin

Back Pivot

Plate

Rotor Actuator

Figure 20

Motor

Drive Assembly Long Tube Spacer

Inner Skid Shoe

Weldment

Motor Drive

Asy Cover

Inner Skid Shoe

Switch Blade (JD-5105-5205-5225-5325-5425-5525,

© 2005 Alamo Group Inc. Section 7 - 9