Control Valve & Valve Controls Installation - Remote Cables
6.There are three holes in the handle assembly that are used to stack the handles on the control handle mount. Install the bolts through the first handle, then the second handle and then through the switch mount plate. Next the three bolts are inserted through the handle mount. (See Figure 17) This is for the cab model (or with remote cable control. The Rops model the valve is mounted to the valve stand and the control handles are connected directly to the valve (See Figure 18). NOTE: Cab models the control handles are installed with the three mounting bolt heads toward operator and the nuts toward the RH Door away from operator (See Figure 20)
7.Install the Operation instruction decal to the valve controls as shown (See Figure 18 & 19)
Push / Pull & Reversing Toggle Switch:
1.The push pull switch mount to the valve stand on non cab tractors (See Figure 19) and to the remote valve control cable handle mount on a cab model (See Figure 18) . On Cab models the switch can be mounted some where else if that is what the customer wanted, however it is recommended that the switch be mounted as shown (See Figure 18 & 19)
ROPS
Model
Shown
Here
Figure 19
Figure 17
Cab
Model
Shown
Here
Figure 18
Figure 20
Switch Blade
© 2005 Alamo Group Inc. | Section 5 - 8 |
