Pump & Drive Shaft Installation:
4.Remove Tractor Upper Bolster Cover Plate. The tractor bolster upper cover will need to be modified and will have to be removed from the tractor to perform this modification. The radiator will need
to be unbolted from the bolster BUT NOT removed from tractor. DO NOT disconnect any hoses for
radiator, air conditioning condenser ,oil cooler or |
|
| |
Upper Plate |
| ||
any electrical wiring, IT WILL NOT BE RE- |
| ||
Under Radiator |
| ||
QUIRED. The Battery should already be re- |
| ||
moved, if not see step one. The radiator has two |
|
| |
bolts on each side that mounts down to the bolster |
|
| |
cover plate (See Figure 7). There are two on each |
|
| |
side LH & RH. Also notice the side protection | Lower Plate |
| |
shield is still installed on the RH side (See Figure | Above Front Axle | Two | |
7), it is easier to work with these shields removed |
| ||
Front Axle | Mounting | ||
but can be done with them left on. | |||
Pivot Pin | Bolts | ||
|
5.You will need some one to help you re- move the cover from under the radiator. Have some one lift the radiator and other components while the cover is removed out toward the front of the tractor. An over head hoist / crane can be used to lift and support radiator, air conditioning con- denser and oil cooler, BUT EXTREME CAUTION MUST be used not to damage the components when lifted.
6.With the cover removed set the radiator and components back down on the tractors bol- ster, do not bolt them down, they will sit there fine as the hoses will not let them fall (See Figure 8). Note the electrical wiring that is left laying across bolster, no electrical connections other that the battery need to be disconnected to remove the cover..
Upper Plate
Upper Plate Front
Retainining Bolts
Figure 6
Upper Plate Side Retainining Bolts
Figure 7
Figure 8
Switch Blade
© 2005 Alamo Group Inc. | Section 3 - 6 |
