Alamo JD-5325, JD-5225, JD-5205, JD-5105 manual JD-5425 & JD-5525

Crankshaft

Alignment

Dimple

Pump & Drive Shaft Installation:

13.Check Modified Bolster Cover for fit. Make certain the cover will not hit the crankshaft pulley, pulley adapter or the splined hub (See Figure 17 & 18). If cover will not hit install the retaining bolts into the cover that were removed when cover was taken off. Leave bolts loose until all bolts have been in stalled this will allow the cover to be moved around for alignment. Once all the bolts are installed tighten all the cover retaining bolts. Caution must

be used to make certain that any hoses or wiring of tractor are routed correctly and will not be dam- aged because they have been moved around or kinked.

14.Re-install Battery. The battery can be rein- stalled now along with the battery hold down. DO NOT reconnect the batter cables to the batter at this time.

15.Re-install Engine Side Shields. Re-install LH and RH side engine shields that were removed.

Use the same mounting hardware that was re-	Figure 14
moved (See Figure 21).

Cut

Hole

Figure 15	Figure 16
	Bolster Plate	JD-5425 & JD-5525
	modification Cut	Shown
	Out Seen From
	Bottom

	Bolster Plate	Axle
	modification Cut
	Out Seen From	Pivot Pin
	Top
Figure 17		Figure 18

Switch Blade (JD-5105-5205-5225-5325-5425-5525, Asy. Man) 05/05

© 2005 Alamo Group Inc. Section 3 - 9