Motorola MVME2600 manual MVME712M Transition Module Installation

1

Hardware Preparation and Installation

7.If necessary, install an MVME712M or MVME761 transition module and cable it to the MVME2603/2604 as described in the following sections of this document.

8.Replace the chassis or system cover(s), cable peripherals to the panel connectors as appropriate, reconnect the system to the AC or DC power source, and turn the equipment power on.

MVME712M Transition Module Installation

This section applies to MVME712M-compatible models of the MVME2603/2604 VME module. With the MVME2603/2604 installed, refer to Figure 1-21and proceed as follows to install an MVME712M transition module:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME modules.

The MVME2600, MVME712-compatible models will be damaged if

!mistakenly connected to the MVME761 transition modules instead of the

Caution correct MVME712 family of boards.

Note In models of the MVME2603/2604 that are configured for MVME712M I/O mode, the pin assignments of VMEbus connector P2 are fully compatible with other transition modules of the MVME712 series.

Inserting or removing modules with power applied may result in damage

!to module components.

Caution

1-44 Computer Group Literature Center Web Site