Motorola MVME2600 manual Hardware Preparation and Installation

1

Hardware Preparation and Installation

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME modules.

Inserting or removing modules with power applied may result in damage

!to module components.

Caution

Dangerous voltages, capable of causing death, are present in this

!equipment. Use extreme caution when handling, testing, and adjusting.

Warning

3.Carefully remove the MVME2603/2604 from its VMEbus card slot and lay it flat, with connectors P1 and P2 facing you.

Avoid touching areas of integrated circuitry; static discharge can damage

!these circuits.

Caution

4.Place the RAM200 mezzanine module on top of the base board. Connector J9 on the underside of the RAM200 should connect smoothly with the corresponding connector J7 on the MVME2603/2604.

1-36 Computer Group Literature Center Web Site