Motorola MVME2600 manual Hardware Installation

Hardware Installation 1

Dangerous voltages, capable of causing death, are present in this

!equipment. Use extreme caution when handling, testing, and adjusting.

Warning

!

Caution

3.Remove the filler panel(s) from the appropriate card slot(s) at the front or rear of the chassis. (You may need to shift other modules in the chassis to allow space for the MVME712M, which has a double- wide front panel.)

4.Attach the P2 adapter board to the P2 backplane connector at the slot occupied by the MVME2603/2604 VME module.

5.Route the 64-conductor cable furnished with the MVME712M from J2 on the P2 adapter board to J2 on the transition module. Be sure to orient cable pin 1 with connector pin 1.

Avoid touching areas of integrated circuitry; static discharge can damage these circuits

6.Secure the MVME712M in the chassis with the screws provided, making good contact with the transverse mounting rails to minimize RF emissions.

7.Referring to the user’s manual for the MVME712M (listed in Appendix D, Related Documentation), route the 50-conductor cable to the internal or external SCSI devices as appropriate to your system configuration. Be sure to orient cable pin 1 with connector pin 1.

Note The SCSI cabling can be configured in a number of ways to accommodate various device and system configurations. Figure 1-21shows a possible configuration for use with internal SCSI devices. For more detailed information on installing the P2 adapter board and the MVME712M transition module, refer to the user’s manual (listed in Appendix D, Related Documentation).

http://www.motorola.com/computer/literature 1-45