Motorola MVME2600 manual P2 Adapter Preparation Three-Row

1

Hardware Preparation and Installation

P2 Adapter Preparation (Three-Row)

The P2 adapter for the MVME761 transition module routes the synchronous and asynchronous serial, parallel, and Ethernet signals to the MVME761. The P2 adapter also has a 50-pin female connector (J2) that carries 8-bit SCSI signals from the MVME2603/2604. To run SCSI devices, you may install an additional transition module that is equipped with a SCSI port, such as the MVME712B.

Preparation of the P2 adapter for the MVME761 consists of installing a jumper on header J1 to enable the SCSI terminating resistors if necessary. Figure 1-16illustrates the location of the jumper header, resistors, fuse, and connectors.

J1	J1
2	2

1	1
SCSI Enabled	SCSI Disabled
(factory configuration)

1-32 Computer Group Literature Center Web Site