D-Link DES-2212 manual Snmp Information and Console Timeout, Software Update Menu

User’s Guide

♦Boot Server IP Address The IP address of the TFTP server where the configuration file is located. This entry is used only if the S/W Update Control is enabled and your boot protocol is tftp only; if you are using bootp-tftpmode, or if Send BOOTP Request on Power Up is enabled, the address will be obtained from the BOOTP server.

♦Boot File Name The pathname of the configuration file on your TFTP server. If you are using D-View as your TFTP server, this is the pathname of the .CFG file on your hard disk. This entry is used only if your boot protocol is TFTP ONLY; if you are using BOOTP&TFTP mode, or if Use Bootp to get IP after start up is enabled, the pathname will be obtained from the BOOTP server.

For more information about DES-2212 configuration files, consult the appendix. For detailed information about using the TFTP and BOOTP servers, consult the D-View User’s Guide .

Figure 6-12. Software Update Menu

SNMP Information and Console Timeout

The System Configuration Menu screen shows various pieces of information about your switch, and allows you to set the System Name, System Location, and System Contact. These settings can be retrieved from the switch using

Using the Console Interface 35