Takes string as the System Contact, corresponding to the SNMP MIB II variable sysContact. This field is used to give the name and contact information for the person responsible for administering the switch. The string can be up to 64 characters long.

syslocation string

Takes string as the System Location, corresponding to the SNMP MIB II variable sysLocation. This field is used to indicate the physical location of the switch for administrative purposes. The string can be up to

64characters long.

baud-rate n

Sets the console port transmission rate used when the port is being used in out-of-band mode. Legal values for the parameter n are: 2400, 4800, 9600, 19200, and 38400.

image-file string

Takes string (which may be up to 64 characters long) as the filename on the TFTP server of the image file to be used. When the switch boots, it will load the given image file from the server and execute it. This command may be used to update the switch’s software when a new version is available from D-Link.

ip-netmask mask

Uses mask as the network mask for the local network. The mask should be in the form xxx.xxx.xxx.xxx, where each xxx is a number between 0 and

255.For a class C network with no subnetting, the netmask should be 255.255.255.0.

ip-default address

Uses address as the hub’s IP address. The address should be in the form xxx.xxx.xxx.xxx, where each xxx is a number between 0 and 255.

auth-trapenable/disable

66

Boot Configuration File

Page 78
Image 78
D-Link DES-2212 manual Syslocation string