Dacor DDW24S Error messages, Problem Solution Guide, Before You Call for Service, Problem, What to Do, What to Do, Error Message, May Be Caused By, May Be Caused By

Before You Call for Service

Error messages

Below is a list of the possible error messages that may appear on the display in some cases and the suggested action.

Error Message	May Be Caused By	What to Do
F:10	Overfilling	Call Dacor Customer Service.
F:11	Water outlet fault	See “Water left in bottom of dishwasher” below.
F:12	Water inlet fault	Make sure water supply valve is on.
F:40	Inlet valve leakage	Turn off the water supply valve and call Dacor
		Customer Service.

Problem Solution Guide

Before you call for service, please review the Problem Solution Guide below.

Problem	May Be Caused By	What to Do
Dishwasher will not start	Main power switch is off	Open door and turn on main power switch on top
(control panel is not lit)		of door before selecting cycle. See page 10.
	Power is disconnected	Make sure power is on at the circuit breaker panel
		and that the power plug is properly connected to
		electrical outlet (if applicable).
	Blown fuse or tripped circuit	Replace fuse or reset circuit breaker. Remove
	breaker	other appliances from circuit.
	Power failure	Contact electric company.
Dishwasher will not start	Door not completely closed	Gently push in on front of door until you hear a
(control panel is lit)	(horizontal lines appear on	click.
	display)
	Controls not set	Make sure dishwasher controls are properly set
		and door is closed. See page 10.
	Child lock activated	See page 3 to bypass. See page 12 to
		deactivate.
	Control panel keys dirty	Clean keys with soft, slightly damp cloth.
	No water supply	Make sure water valve is turned on.
	Water supply line blocked	Make sure water supply line to dishwasher is not
		kinked.
	Drain pump clogged (loud	Disconnect power and clean entire filter system
	buzzing sound)	and drain pump. See page 13. Reconnect power
		and attempt to restart. If problem persists, shut off
		the water supply, disconnect power and call for
		service.
Water left in bottom of	Dishwashing cycle not	Allow dishwasher to complete cycle.
dishwasher near filters,	complete
dishwasher will not	Obstruction in the drain hose	Check for kinked drain hose. Disconnect end of
drain
	or air gap is plugged	drain hose. Check for debris in hose or any other
		part of drain/plumbing system. NOTE: The cone-
		shaped part of the hose must be at least 1/2”
		(1.3 cm).
	Filter system clogged	Clean entire filter system. See page 13.
	Debris in the drain pump	Clean the drain pump/filter system. See page 13.

16