Dacor ER36D-C, ER48D-C manual

Installation Instructions

Epicure ® Range

For Use with Models: ER36D, ER36D-C, ER48D, ER48D-C

THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF

ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS APPLIANCES.

Part No. 100843 Rev. R

Contents

Page IMPORTANT: Specifications contained within are subject to change without notice No liability is assumed by Dacor® for changes in specifications Important Information About Safety Instructions Safety Symbols and Labels Page Model Identification ER36D-C-SCH/NG/H Model and Serial Number Location NEMA 14-50PPlug NEMA 10-50PPlug NEMA 14-50R Receptacle All tolerances: ±1/16” (±1.6mm) Gas and Electrical Service The installation must allow for the following: Standard Cutout with Range Hood Cutout with Optional ERV Raised Vent (Top View) Unpack the Range Parts List Level and Adjust the Range Height Install the Anti-TipBracket and Foot Top View Installing an ERV Raised Vent (Optional) Installing a Backguard (Optional) To install a backguard: Trim Removal Sliding the Backguard into Place Installing a Backguard (Continued) Backguard Installation Removing the Oven Door Releasing the Door Hinges Securing the Support Brackets on 24 inch Backguard Connecting Conduit to the Range Gas and Electrical Access Covers Connecting 4 Wire Conduit to Range Connecting 3 Wire Conduit to Range Where Local Code Permits Connecting the Conduit to the House Electrical Junction Box 4 Wire Conduit Connection to Junction Box 3 Wire Conduit Connection to Junction Box Junction Box - 4 Wire Connection with External Ground Insulated Pipe Jumper Connecting an Appliance Wire to the Range - Where Local Code Permits 4 Wire Appliance Cord Connection 14-50PPlug 3 Wire Appliance Where Local Code Before sliding the range into the cabinet: Permits 10-50PPlug Re-installingthe Oven Door(s) Icons on Center Burner Knobs Door Installation Icons on Outer Burner Knobs Crown Burner Installation Stack Burner Installation Normal Flame