Installation Instructions

Preparing for Installation

WARNING

•If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the dealer, the gas supplier or a licensed electrician.

•Before installing the range, you must locate and secure the anti-tip bracket to the floor.

IMPORTANT: Within the Commonwealth of Massachusetts, this appliance must be installed by a licensed plumber or gas fitter.

Unpack the Range

Unpack the parts box and verify that all required components have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance. The customer must report cosmetic issues within 30 days of installation.

Parts List

• 3 Grates

• 6 Knobs

•2 Small Stack Burner Caps • Anti-tip Bracket w/Screws

•2 Small Stack Burner Rings • Meat Probe

•2 Large Stack Burner Caps • Griddle

•2 Large Stack Burner Rings • Wok Ring

• 2 Crown Burner Caps

•

Stainless Steel Cleaner

•

2

Crown Burner Rings

•

Pry Stick

•

2

Crown Burner Heads

•

Literature Kit

•

1

GlideRack ™ Oven Rack

•

Ignitor Cleaning Brush

•

2

Standard Size Racks

•

Broiler Pan/Grill

•3 18” Racks (ER48D only)

See the use and care manual for a list of optional parts and accessories.

NOTE: The range also includes a thread ring removal tool for the crown burners (PN101539). It is taped in place behind the right side of the kick panel when the range is shipped from the factory. Leave it in place unless the spill trays need to be removed for service. Return it after use so that it is available if needed in the future.

Thread Ring Removal

Tool Location

WARNING

Do not connect the unit to gas or power before proceeding with the following sections.

Level and Adjust the Range Height

1.Adjust the height by turning the bottom part of each leg as shown. Raise or lower the range until the trim around the cooktop area is slightly higher than the counter-top. If installing with a raised vent, adjust the height so that the trim matches the height of the vent’s top in the down position.

Rear Leg

Back of Range

 

1 1/4” *

 

up

Anti-Tip Foot

down

(location varies)

*Distance to floor: 4 1/16” to 5 5/16”

2.Use a level to make sure that the range does not tilt front to back or side to side. Readjust the legs if necessary.

Install the Anti-Tip Bracket and Foot

1.Locate the anti-tip foot and lower it until it is 1/16" (2mm) off the floor. See the bottom left diagram.

2.Locate the anti-tip bracket included in the parts box.

3.Install the anti-tip bracket on the floor using the four included screws. The mounting location varies according to the model. See the diagram below for location.

Top View

J

K

Range

Back of RangeRight Side

Panel

ANTI-TIP BRACKET PLACEMENT

Dimension

ER36D

ER48D

J

7 1/2” (191mm)

19” (483mm)

K

6 1/2” (165mm)

6 1/4” (159mm)