Installation Instructions
Installing a Backguard (Continued)
5.Fasten the backguard and the stainless steel trim piece in place with the five (5) existing chrome plated screws.
6.Secure the rear of the backguard to the back of the range with the eight (8) existing hex screws.
Chrome Plated
Screw, 5 Places
Backguard | Hex Screw, |
| 8 Places |
Backguard Installation
7.On the 24 inch backguard: Secure the “C” channels on the 24 inch backguard to the brackets mounted on the range chassis using eight (8) hex screws from the kit. Insert the screws through the holes in the back side of the backguard.
Removing the Oven Door
WARNING
•Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury.
•Do not lift or carry the oven door by the door handle.
NOTE: When installing a backguard, always install it before sliding the range into place. See page 8.
To make the range easier to move, remove the door(s) to reduce weight.
1.Open the door to its fully opened position.
2.Rotate the catch over the retaining arm on each hinge.
Catch
Retaining Arm
Releasing the Door Hinges
3.Lift the oven door to about a 15° angle from the vertical position.
4.Hold the door with both hands just below the handle and pull it away from the oven while continuing to lift.
Hex Screw,
8 Places