Connectionsti
•There are a variety of ways to connect the HDD/DVD Recorder to your TV and other equipment. Use only one of the connections described below. Whichever TV connection you use will work with all input sources.
•Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best connections.
•For better sound reproduction, connect the HDD/DVD Recorder’s AUDIO OUT jacks to the audio in jacks of your amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 16.
Caution
•Make sure the HDD/DVD Recorder is connected directly to the TV, and the TV is set to the correct video input.
•Do not connect the HDD/DVD Recorder’s AUDIO OUT jack to the phone in jack (record deck) of your audio system.
•Do not connect the HDD/DVD Recorder via your VCR. The DVD image could be distorted by the copy protection system.
If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the HDD/DVD Recorder.
Use the supplied RF cable to connect between the HDD/DVD Recorder’s OUT (TO TV) jack and the antenna input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all cable channels).
Connecting a TV
Choose one of the following TV connections, depending on the capabilities of your equipment.
Rear of TV
COMPONENT/PROGRESSIVE VIDEO INPUT |
| ANTENNA | |||
INPUT |
|
|
|
| INPUT |
| Pr | Pb | Y |
|
|
S | C |
|
| V | R |
INTRODUCTION CONNECTIONS
Connecting Antenna/Cable
1Disconnect the antenna/cable from the rear of your TV.
2Connect this cable to the jack marked ANT IN (FROM ANT.) on the rear panel of the HDD/DVD Recorder.
Antenna Antenna
Rear of HDD/DVD Recorder
RF Connection
Connect the ANT OUT (TO TV) jack on the HDD/DVD
Flat Wire (300ohm)
Cable TV Wall Jack
Recorder to the antenna in jack on your TV using the supplied
300/75ohm Adapter | OR | OR |
(Not supplied) |
Rear of HDD/DVD Recorder
This set doesn’t have a modulator output. However it still applies the RF through Output.
Scart Connection
1Plug a scart cable into the scart socket EURO AV1 at the back of the HDD/DVD Recorder and the corresponding scart socket at the back of the TV set. (V)
2Plug a scart cable into the blue scart socket EURO AV2/DECODER at the back of the HDD/DVD Recorder and the corresponding scart socket at the back of the Decoder.
15
