06ManualMandoDaitsuEng 21/12/06 16:17 P‡gina 93
COOLING/FAN ONLY OPERATION
Start
Connect the unit with the power.
The OPERATION lamp on the display panel of the indoor unit starts flashing.
(1) Mode select button (MODE)
Select COOL, HEAT (cooling only type without), or FAN ONLY.
(2) Temperature button (TEMP)
Set the desired temperature.
Cooling 21¼C or higher
Heating 28¼C or lower
(3) Fan speed button (FAN SPED)
Select any of the "AUTO" "LOW", "MED" and "HIGH".
(4) ON/OFF button
Push this button to start the air conditioner.
The OPERATION lamp on the display panel of the indoor unit lights. The opera- ting mode is selected in accordance with the room temperature and operation starts after approximately 3 minutes (If you select FAN ONLY mode, the unit will start immediately.)
Stop
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1,3, and 4 to select this mode.
ENGLISH
93
