Dakota Digital operation manual CMX High Performance Material & Coating Thickness Gauge

CMX High Performance Material & Coating Thickness Gauge

ESC key multiple times to tab left until the CAL menu is highlighted and displaying the submenu items.

3)Use the UP and DOWN arrow keys to scroll through the sub menu items until MATL 1PT is highlighted.

4)Press the ENTER key to display the Digits Edit Box.

5)Press the UP and DOWN arrow keys to scroll the highlighted value.

6)Press the LEFT and RIGHT arrow keys to scroll the digit locations.

7)Repeat steps 5 & 6 until the known thickness value is correctly displayed.

8)Press the OK key to calculate the velocity and return to the menu screen, or ESC to cancel the one point calibration.

9)Finally, press the MEAS key to return to the measurement screen and begin taking readings.

Note: CHECK YOUR CALIBRATION! Place the transducer back on the calibration point. The thickness reading sho uld now match the known thickness. If the thickness is not correct, repeat the steps above.

At some point there may become a requirement for improved accuracy over a smaller measurement range. In this case, a two point calibration would be most suited for

49