Danby DBD5L owner manual Connecting The Beverage Dispenser, Preparing A Standard 5 Liter Mini Keg

CONNECTING THE BEVERAGE DISPENSER

Preparing A Standard 5 Liter Mini Keg

USING THE YELLOW ADAPTOR

To connect the Yellow Adapter to a standard 5 liter mini keg, follow these instructions.

NOTE: MAKE SURE ALL COMPONENTS ARE PROPERLY SANITIZED PRIOR TO EACH USE.

PREPARING THE STANDARD 5 LITER MINI KEG

1.Screw the YELLOW RISING PIPE into the YELLOW ADAPTER. Make sure there is an o-ring inside the RISING PIPE. (See Figure 2)

2.Remove the plug from the top of the keg tap to ventilate the keg. This releases the pressure build-up in the top of the keg. The ventilation openings are designed differently per keg type. Check the top ventilation opening to make sure the opening is wide enough for the YELLOW RISING PIPE. If there are parts in the way, such as a plastic edging, make sure it is removed. It may be necessary to use a screwdriver or pliers to do so.

3.Insert the YELLOW RISING PIPE (attached to the YELLOW ADAPTER) into the top ventilation opening of the mini keg. (See Figure 3)

4.If the YELLOW RISING PIPE does not fit into the tap, you may be required to remove the plastic seal completely from the ventilation tap using pliers. If this is required, insert the provided BLACK RUBBER SEAL (See “Parts & Accessories” on page 7) into the keg before inserting the RISING PIPE. This will create a tight seal between the keg and the RISING PIPE. Keep a cloth or towel on hand, as the beverage could spill.

FASTEN RISING PIPE INTO WHITE ADAPTER (turn in clockwise Direction)

Figure 2

SIdes Snap & Lock into place around edges

BEVERAGE	AIR
OUT	IN

5. Make sure the YELLOW ADAPTER fits completely down on Figure 3 top of the mini keg and the sides of the ADAPTER snap and

lock into place around the edges of the mini keg. (See Figure 3)

10