CONNECTING THE BEVERAGE DISPENSER
Preparing A Standard 5 Liter Mini Keg (cont’d)
USING THE YELLOW ADAPTER (continued)
CONNECTING THE MINI KEG TO THE
DISPENSER
13.Insert the 5 liter mini keg (with the ADAPTER connected) into the dispenser. Insert the YELLOW MALE CONNECTOR attached to the
(See Figure 6). Make sure you hear a “locking click”
14.Take the YELLOW MALE CONNECTOR attached to the DISPENSING TUBE and insert that end into the BEVERAGE OUT opening of the YELLOW ADAPTER (See Figure 6). Make sure you hear a “locking click”
15.Make sure there are no kinks in the TUBES. There needs to be an even air flow from the unit to the keg and even liquid flow from the keg to the tap. Also make sure the keg is centered in the cooling compartment of the unit. This ensures even cooling throughout.
To connect dispensing tube to Yellow adapter
PUSH
UNTIL
LOCKING
CLICK
Figure 6
n
TURNING ON THE AIR PRESSURE
16.Before closing the lid of the dispenser, you need to turn on the air pressure which will generate the power to dispense the beverage.
17.In the upper left hand corner of the under side of the lid, there is a black switch, labeled AIR ON or AIR OFF, which can be moved up or down. Move the switch to the
AIR ON position (See Figure 7). Once you close the lid the | Figure 7 | |
power will be activated to turn the air pressure on. | ||
|
18.When the dispenser is not being used, make sure the switch is in the AIR OFF position.
CLOSE THE LID
To turn on the power, please refer to “Switching on the
Power” on page 15
AIR ON/OFF SWITCH
12
