BEFORE YOU CALL FOR SERVICE
TROUBLE SHOOTING
Problem | PossibleCauses | WhatTo Do |
|
|
|
1)The beverage dispenser is not cooling
1) No power supply | 1) Make sure the dispenser is plugged into a 3 prong | ||
1a) | Low voltage | outlet | |
1a) | Make sure the dispenser is plugged into a proper | ||
1b) | Blown fuse | 120V outlet | |
1b) | Change fuse. It is recommended that a qualified |
electrician change the fuse on the dispenser
2)Beer or beverage is not being dispensed
3)The dispenser temperatre display is not illuminated
4)Excessive foam, spilling, or spraying occurs
2)The mini keg or container is empty.
2a) The DISPENSING or
2b)The air pressure switch is in the AIR OFF position. 2c) Air is leaking.
3) No power
3a) The power switch remains in the OFF (O) position.
4) First glass
4a) The mini keg is not cold enough, or has been shaken.
2) Change the keg or container.
2a) Make sure the TUBES are not kinked when connected. If necessary, turn the keg in the dispenser to even out the TUBES.
2b) Switch the air pressure to the AIR ON position
2c) Make sure there is an
3)Make sure the dispenser is plugged into a 3 prong outlet.
3a) Push the power switch to the ON ( l ) position.
4)The first glass from a keg can have too much foam. This is normal.
4a) Always
5)The dispenser is making a humming noise
4b) The DISPENSING TUBE or
4c) Dispensing tap is not open enough
5)The air pressure is turned off
4b) Make sure the TUBES are properly connected. If necessary, change the TUBES. Make sure the ADAPTER is securely fastened to the mini keg. If necessary,
4c) Pull the tap handle completely down to ensure the tap opens up.
5)The air pressure switch is turned to the ON position.This is normal. If not in use, turn to the OFF position.
20