Danby DBD5L Preparing A Standard 5 Liter Mini Keg cont’d, Connecting The Beverage Dispenser

CONNECTING THE BEVERAGE DISPENSER

Preparing A Standard 5 Liter Mini Keg (cont’d)

USING THE YELLOW ADAPTER (continued)

DISPENSING TUBE FOR YELLOW ADAPTER

The DISPENSING TUBE will be pre-assembled, but if assembling is required please follow these instructions:

DISPENSING TUBE WITH BLACK STOPPER

YELLOW MALE CONNECTOR

METAL CLIP

8.Place the CLIP over the end of the DISPENSING TUBE

9.Insert the YELLOW MALE CONNECTOR into the

opening of the end with the CLIP. Attach the CLIP so it seals the MALE CONNECTOR into place under the TUBE. (See Figure 4)

10.When finished, take the other end of the DISPENSING TUBE (the side with nothing attached) and insert it into the opening of the tap. (See Figure 5)

11.Pull the TAP HANDLE down so the DISPENSING TUBE fits through the tap. To do this, you may have to push and thread it through. Make sure the BLACK STOPPER fits securely in the inlet just before entering the tap.

(See Figure 5)

12.The DISPENSING TUBE needs to go all the way

through the spout. The TUBE should be slightly exposed below the bottom of the tap. (See Figure 5)

YELLOW MALE CONNECTOR

DISPENSING TUBE

Attach METAL CLIP so it seals MALE CONNECTOR in place

Figure 4

BLACK STOPPER

TUBE IS

EXPOSED

Figure 5

11