Danby DBD5L owner manual Depressurize To Disconnect the Mini Keg & the Container

OPERATING THE BEVERAGE DISPENSER

Depressurize To Disconnect the Mini Keg & the Container

It is very important to depressurize the mini keg or container when you are finished using them. If the pressure is not released, remaining high pressure could lead to spraying or spilling. Follow these directions to ensure proper depressurization.

NOTE: 5 liter mini kegs are empty when only foam is being dispensed from the beverage dispenser. If necessary you can also disconnect partially full mini kegs.

1.Switch OFF the dispenser.

2.To depressurize the keg or container, pull down the tap handle to dispense all additional beverage which may be in the unit due to the pressure (ie. beverage that is in the RISING PIPE and ADAPTER). When the dispensing beverage stops, gently release the tap back to its resting position.

3.Open the lid of the dispenser. If not already done, turn the air pressure switch to the AIR OFF position.

4.Disconnect the tubes while holding the adapter in place:

YELLOW ADAPTER - First, pull out the MALE CONNECTOR attached to the AIR-CONNECT TUBE from the ADAPTER, then pull out the MALE CONNECTOR attached to the DISPENSING TUBE from the ADAPTER. Then, push down on the metal press tabs (See Figure 19).

To disconnect dispensing tubes

PUSH DOWN ON METAL

TAB

Figure 19

WHITE BEVERAGE CONTAINER ADAPTER- Pull the DISPENSING TUBE off of the DRINK OUT pipe of the ADAPTER. Then, pull off the AIR-CONNECT TUBE from the AIR IN pipe of the ADAPTER. It may be necessary to pull hard.

5.Once the TUBES have been disconnected from the ADAPTERS, pull the tap handle toward you. Dispense any unnecessary liquid from the DISPENSING TUBE, then pull the TUBE out of the tap.

6.Gently release the tap handle back to its resting position.

7.Remove the mini keg or container from the beverage dispenser.

8.To disconnect the ADAPTERS:

YELLOW ADAPTER: unclip the sides of the ADAPTER which cover the keg edges. Pull the ADAPTER and the RISING TUBE out of the keg. Unscrew the RISING PIPE and the ADAPER.

WHITE BEVERAGE CONTAINER ADAPTER- push in the locking mechanisms on either side of the ADAPTER and pull it off of the container. It may be necessary to pull firmly due to air pressure build-up. Pull out the RISING PIPE from the ADAPTER.

9. Thoroughly wash and clean the dispenser and all parts used.

NOTE: If you want to store the mini keg or container, see “Shelf Life of Mini Kegs” on page 16

17