Remote Control Operating
Instructions
1.Sending Signal: The remote control must be aimed directly at the
If the main unit again fails to respond;
Check the following:
•Are the receiver and the remote unit within the required 7 meter (23 ft.) operating distance?
•Is the receiver window on the main unit partially blocked and/or obscured?
•Are the batteries correctly installed inside the remote (positive+ /
•Check the batteries. If low, replace.
2.Setting/Adjusting Time of Day Clock (Remote Control): When the batteries are first installed, the clock display flashes “0:00”. Press the MIN button to set the correct (minute) time. Each time the MIN button is pressed the time is increased in 10 minute increments. The time sets automatically (stops flashing) after 5 seconds. Press/hold the HOUR button to select/change the correct hour time. (time flashes) Each time the HOUR button is pressed the time will increase in 1 hour increments. The time automatically sets (stops flashing) after 5 seconds. When the main unit is swithed on using the remote control, the time on the main unit will automatically adjust to the time set on the remote control.
3.Mode Setting: Press the “Mode” button to select operating mode. Each time the button is pressed will advance to a different setting
4. Temperature Setting: Press the remote
+ | buttons to select the desired |
C/F | operating temperature. |
- | Each time a button is |
| pressed the temperature will |
increase/decrease 1°C/F. The temperature selected will appear in the remote display. When the main unit is swithed on using the remote control, the temperature on the main unit will automatically adjust to the temperature set on the remote control. Temperature ranges from
5.Fan Speed Setting: Press the “Fan” button to select the operating fan speed. Depending on the mode selection, the fan button will advance to a different fan speed
MODE | FAN SPEEDS |
Cool |
|
Dry | Low |
Fan |
|
AUTO |
LCD Window |
| |
3 | 5 | |
4 | ||
6 | 8 | |
Timer On/Off | ||
2 | ||
|
18