Datamax M-4206 manual Incorrect. Pressing Not correct. The default

	Problem	Possible Cause		Solution
Label Alignment is		Label Alignment Length is	¾	Set Label Alignment to AUTO. Press and hold	FEED until
incorrect. Pressing		not correct. The default		paper moves for automatic Label Alignment length
	FEED successively	Label Alignment Length is		measurement.
results in a label length		1.00”, and will result in		~OR~
longer than actual, one-		this behavior when any
inch.		larger label length is used	¾	Measure the label length and use the Setup Menu to set the new
		without setting the		length. Print a Database Configuration label to ensure the new
		appropriate length		length has been set.
Tear Mode is selected		Another present position	¾	Disable the Present Sensor.
but the label stop		has been determined.		~OR~
position (present		Enabling the Present
position) is not far		Sensor causes the label	¾	Ensure the host computer is not providing a Present Distance
enough forward.		stop position (present		shorter than is required for the Tear Bar.
		position) to be
		approximately 0.1” behind
		the peel bar.
		~OR~
		The Present Adjust value	¾	Use the Setup Menu to modify the Present Adjust value.
		is not correct.
Tear Mode is selected		Another present position	¾	Ensure the host computer is not providing a Present Distance
but the label stop		has been determined.		longer than is required for the Tear Bar.
position (present
position) is too far		~OR~
forward.
		The Present Adjust value	¾	Use the Setup Menu to modify the Present Adjust value.
		is not correct.
The	ERROR light	The label supply is empty	¾	Load media.
illuminates during label
alignment.

M-4206 29