Definitive Technology Solo Cinema Integrated Home Theater System SOURCE 4 INPUT HDMI AUDIO SYSTEM

On-Screen Display (OSD) Set-up Menu Functions

SoloCinema XTR comes out of the box ready to use. Most people will never have to access any of the following menu functions. But just in case, it is good to be familiar with them. The on screen menu and brief explanations are shown below. To start, with your TV ON, press the MENU button on the SoloCinema remote. The OSD screen appears on your TV. To exit the menu at any time, just press the MENU button. The functions:

SOLOCINEMA XTR MENU

DOLBY VOLUME

IR REPEATER

IR LEARN

SUB CONNECTION

SSA IMMERSION

SOURCE 4 INPUT

HDMI AUDIO

SYSTEM

1.DOLBY VOLUME: This digital signal processing technology evens out the volume level of whatever you watch. TV ads that might blast a volume level louder than your favorite program are instead heard at consistent, equal volume levels. Dolby Volume maintains the same level when you switch sources, or change cable channels. The factory preset is ON. To de-activate Dolby Volume, use the arrow keys to highlight DOLBY VOLUME, and press the right cursor arrow to select CONTROL. Press the right cursor again to navigate to the On/off selection. Press the cursor’s down arrow to select OFF. Press ENTER or the left cursor to confirm this selection.

Dolby Volume Modeler optimizes the system performance for low level listening, when the volume is down, and defaults to OFF in Music mode. The factory preset is ON.

DOLBY VOLUME

CONTROL

MODELER

2.IR REPEATER: The repeater re-transmits the signal from any remote. When table-top mounting SoloCinema XTR, it is possible that the bar can block the TV’’s IR receivers. IR Repeater turns on / off the IR “flashers”located on SoloCinema XTR’s rear panel, and re-sends the IR signal to the TV’s remote eye. The factory preset is OFF. There is also a 1/8” IR input mini-jack connection for aftermarket IR systems, if required.

17