Dell 110L manual Quick Reference Guide

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

•If a failure is detected, the computer stops and beeps. To stop the assessment and restart the computer, press <n>; to continue to the next test, press <y>; to retest the component that failed, press <r>.

•If failures are detected during the Pre-boot System Assessment, write down the error code(s) and contact Dell before continuing on to the Dell Diagnostics.

If the Pre-boot System Assessment completes successfully, you receive the message Booting Dell Diagnostic Utility Partition. Press any key to continue.

6Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

Starting the Dell Diagnostics From the Optional Drivers and Utilities CD

1Insert the Drivers and Utilities CD.

2Shut down and restart the computer.

When the DELL logo appears, press <F12> immediately.

If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut down your computer and try again.

NOTE: The next steps change the boot sequence for one time only. On the next start-up, the computer boots according to the devices specified in system setup.

3When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.

4Select the CD/DVD/CD-RW Drive option from the CD boot menu.

5Select the Boot from CD-ROM option from the menu that appears.

6Type 1 to start the ResourceCD menu.

7Type 2 to start the Dell Diagnostics.

8Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed, select the version appropriate for your computer.

9When the Dell Diagnostics Main Menu appears, select the test you want to run.

22

Quick Reference Guide